Mechanical Downtilt Supporting Arm
The adjustment range of the mechanical downtilt supporting arm is –20° to +20°.
Capacity
Table 4-5 AAU5611 NR capacity
| Frequency Band | TX/RX Channel | NR Capacity |
| 2600 MHz | 64T64R | A maximum of two carriers are supported. |
Table 4-6 AAU5611 LTE TDD capacity
| Frequency Band | TX/RX Channel | LTE TDD Capacity |
| 2600 MHz | 64T64R | A maximum of two carriers are supported. |
Table 4-7 AAU5611 TN (LTE TDD+NR) capacity
| Frequency Band | TX/RX Channel | LNR Capacity |
| 2600 MHz | 64T64R | A maximum of one NR carrier and one LTE TDD carrier are supported. |
ECPRI Port Specifications
Table 4-8 eCPRI port specifications
| Item | Specifications |
| Number of eCPRI ports | 2 |
| eCPRI port rate (Gbit/s) | 10.3125 or 25.78125 |
| eCPRI-based networking | Load sharing or star |
| Maximum distance from the BBU | l When 25 Gbit/s optical modules are used, the length of optical fibers between the BBU and AAU must be less than 10 km. l When 10 Gbit/s optical modules are used, the length of optical fibers between the BBU and AAU must be less than 20 km. |
Output Power
Table 4-9 AAU5611 output power
| Frequency Band | Total Power |
| 2600 MHz | 160 W |
Static Sensitivity
Table 4-10 Static sensitivity of the AAU5611 NR
| Frequency Band | Typical NR Static Sensitivity |
| 2600 MHz | –98.2 dBm for 1 RX |
When the ambient temperature of the NR static sensitivity is 25°C, the test configuration should comply with 3GPP TS 38.104 (QPSK, R = 1/3, 51 RBs).
Table 4-11 Static sensitivity of the AAU5611 LTE TDD
| Frequency Band | Typical LTE TDD Static Sensitivity |
| 2600 MHz | –104.2 dBm for 1 RX |
When the ambient temperature of the LTE TDD static sensitivity is 25°C, the test configuration should comply with 3GPP TS 36.141 (QPSK, R = 1/3, 25 RBs).
Power Consumption
Table 4-12 Power consumption of an AAU5611
| Frequency Band | Typical Power Consumption |
| 2600 MHz | 960 W |
The typical power consumption refers to the power consumption when the ambient temperature is 25°C and the traffic load reaches 50%. The actual power consumption has a 10% deviation from this value.
Power Supply
Table 4-13 Power supply
| Item | Specifications |
| Input power | –48 V DC; voltage range: –36 V DC to –57 V DC |
Equipment Specifications
Table 4-14 Equipment specifications of an AAU5611
| Item | Specifications |
| Dimensions (H x W x D) | 965 mm x 470 mm x 220 mm |
| Weight | 47 kg (not including mounting kits) |
Environmental Specifications
Table 4-15 Environmental specifications
| Item | Specifications |
| Operating temperature | –40°C to +55°C (without solar radiation) |
| Operating wind speed | 150 km/h |
| Rated wind velocity | 200 km/h |
| Wind load | l Front: 710 N (Assume that the wind speed is 150 km/h.) l Side: 265 N (Assume that the wind speed is 150 km/h.) l Rear: 740 N (Assume that the wind speed is 150 km/h.) |
| Relative humidity | 5% RH to 100% RH |
| Atmospheric pressure | 70 kPa to 106 kPa |
| Operating environment | The operating environment must comply with the following standards: l 3GPP TS38.104 l 3GPP TS36.141 l 3GPP TS37.105 l ETSI300019-1-4 V2.2.1 (2014-04) Class 4.1: "Non-weatherprotected locations" |
| Shockproof protection | l YD5083-1999: Interim Provisions for Test of Anti-seismic Performances of Telecommunications Equipment (telecom industry standard in People's Republic of China) l ETSI300019-2-3 (V2.4.1 2015-12) l GR63-CORE,Issue 4, April 2012 Zone4 |
| Ingress protection rating | IP65 |
| Surge protection | l IEC 62305-1 Protection against lightning - Part 1: General principles l IEC 62305-3 Protection against lightning - Part 3: Physical damage to structures and life hazard l IEC 62305-4 Protection against lightning - Part 4: Electrical and electronic systems within structures l ITU-T K.35 Bonding configurations and earthing at remote electronic sites l ITU-T K.56 Protection of radio base stations against lightning discharges l ITU-T K.97 Lightning protection of distributed base stations l ETSI EN 300 253 Environmental Engineering (EE): Earthing and bonding configuration inside telecommunications centers l YD 2324-2011: Lightning protection requirements and test methods for radio base stations l GB/T 50689-2011: Code for design of lightning protection and earthing engineering for telecommunication bureaus (stations) |
Дата добавления: 2022-12-03; просмотров: 24; Мы поможем в написании вашей работы! |
Мы поможем в написании ваших работ!